Power type steam Configuration 4-6-0 Driver dia. 73 in (1.854 m) | Total produced 185 Gauge 5 ft 3 in (1,600 mm) | |
 | ||
Builder VR Newport, Ballarat & Bendigo Workshops | ||
The A2 class was an express passenger locomotive that ran on Victorian Railways from 1907 to 1963. A highly successful design entirely the work of Victorian Railways' own design office, its long service life was repeatedly extended as economic depression and war delayed the introduction of more modern and powerful replacement locomotives.
Contents
History
The introduction of the A2 class marked a turning point in Victorian Railways locomotive design, as it was entirely designed by VR engineers of the newly established Locomotive Design Section and the entire class built in-house at Victorian Railways workshops.
Production
Based on the success of the prototype A2 572, a total of 125 Stephenson valve gear A2 locomotives were built between 1907 and 1915. The design was then altered to incorporate larger diameter cylinders, a higher pressure boiler and Walschaerts valve gear, and a further 60 locomotives of this design were produced between 1915 and 1922.
Regular service
For over forty years, the A2 was the main express passenger locomotive on the VR, hauling intrastate and interstate services. With a maximum permitted speed of 70 miles per hour (112.7 km/h) the A2 was instrumental in the acceleration of timetables on many lines in the years following its introduction. They famously ran the Geelong Flier service (the first "named" train in Victoria) slashing journey times between Melbourne and Geelong from 90 minutes to 63 and finally 55 minutes, a time not significantly improved upon until the introduction of 160 km/h Regional Fast Rail services in 2006.
A2s were also used to haul a number of special services, such as the Royal Trains for the Prince of Wales' and the Duke of York's Australian tours in 1920 and 1927 respectively. Towards the end of their lives, A2 995 and 996 also had the distinction of hauling the last broad gauge Spirit of Progress service into Melbourne on 16 April 1962.
With their comparatively high tractive effort (the Walschaerts A2 had a higher nominal tractive effort than any other VR locomotive, regardless of type, until the introduction of the C class 2-8-0 of 1918) they also saw widespread use as a fast goods locomotive, particularly in their later life. It was reported as normal practice as early as the 1920s for A2 class locomotives requiring adjustment to axle boxes (axleboxes) and other moving parts to be swapped from passenger to lower-speed freight service to extract greater work from them between overhauls.
In 1933, two A2 class locomotives set a haulage record for Victorian Railways when they took a 75 truck 1,598-long-ton (1,624 t) wheat train from Benalla to Seymour.
Although initially limited to principal mainlines due to their comparatively heavy axle load, gradual upgrades to secondary lines saw the route availability of the class expand, together with the range of services they hauled.
In 1928, the A2 was replaced on the principal North-eastern line Sydney Limited and Albury Express services by the considerably more powerful three-cylinder S class Pacifics. However, new locomotive development ground to a halt during the 1930s as the Great Depression severely affected both VR traffic volumes and operating revenues, and the A2 continued as the main express passenger power on all other VR mainlines.
Design Improvements
The majority of A2 locomotives were originally built with saturated steam boilers. The class were gradually fitted with superheaters, and to differentiate between the two variants the saturated steam locomotives were renumbered as A1 class, each being reclassified as A2 class again when fitted with a superheater. The last of the A1 class, No. 808, was converted in October 1949.
Experiments were conducted in 1923-4 with A2 800 using Pulverised Brown Coal (PBC) burning equipment, however the experiment was discontinued and the locomotive returned to black coal operation.
The A2 class, along with other post-1900 VR steam locomotive designs, was equipped with electric lighting from 1926 onwards. Automatic Staff Exchange equipment to allow non-stop high-speed running between track sections was also fitted from 1926 onwards.
Modified front end
In 1933, C class heavy goods locomotive C 5 was equipped with a new front end, based on the Association of American Railroads (AAR) design of self-cleaning smokebox, to improve steaming qualities. The results were very promising, and in 1934 A2 998 was selected for a series of further tests aimed at further front end improvement, conducted under the direction of VR Rolling Stock branch engineer, Edgar Brownbill.
Experiments based on the work of Dr Wagner of the Deutsche Reichsbahn and E. C. Young of the University of Illinois were conducted, with final modifications to the A2 locomotive including:
The sum result of these changes was a significant improvement in power and available tractive effort. Maximum drawbar horsepower increased some 40% from 860 hp (640 kW) at 26 mph (42 km/h) to 1,230 hp (920 kW) at 32 mph (51 km/h). The improvement was such that the VR was able to further accelerate services hauled by the A2, with the steeply graded 100 3⁄4 mi (162.1 km) Melbourne to Bendigo express running time being cut from 162 to 145 minutes, and literally hours being cut from the schedule of the Melbourne to Adelaide Overland express.
Modified Front End was an extremely cost effective improvement given that it allowed the VR to defer new locomotive construction through improvements to existing locomotives that at the time cost just £140 ($280) per locomotive. It was so successful that not only was the entire A2 fleet converted during 1936–39, but also the C, K, N, S and X class locomotive fleets, and its principles were also incorporated into the design of all subsequent steam locomotives built for VR.
Other changes
In 1935 an experimental A.C.F.I. (Accessoires pour les Chemins de Fer et l'Industrie) feedwater heater was fitted to A2 973. However, there was not sufficient improvement in efficiency for the equipment to be fitted to other locomotives and it was removed twelve years later.
With the reduced exhaust blast resulting from the revised smokebox, smoke deflectors were fitted to prevent drifting smoke from obscuring visibility.
In the years following World War II, problems with the quality and availability of coal supplies caused VR to order the conversion of all 60 Walschaerts A2s to oil firing.
Late in their life, some of the A2s also received Boxpok driving wheels as their conventional spoked wheels began to suffer fatigue cracks with age and mileage.
Later Years
In 1939, by which time most of the class was already over twenty-five years old, World War II broke out. The massive increase in traffic on the VR the war effort brought saw these ageing locomotives subjected to a punishing regime of heavy utilisation and minimal maintenance.
With VR's locomotive workshops switched to production of armaments and all available manpower given to the war effort, plans to eliminate the double-headed A2 operations on Melbourne-Adelaide passenger services with the introduction of more powerful H class 4-8-4 locomotives and additional S class locomotives did not come to fruition. The extra S class locomotives were never built and the line to Adelaide did not receive the necessary upgrades to take the weight of the H class.
The A2's principal express passenger role continued into the postwar years as the VR, struggling with a backlog of repairs and limited capital expenditure, deferred new passenger locomotive construction. It was not until March 1946 when the first of the class, A2 878, was withdrawn from service.
In 1951, when the first of 70 new R class 4-6-4 express passenger locomotives were introduced, the A2 was finally superseded. In 1953, no fewer than 53 A2s went to scrap, followed by 36 more in 1954. However, many of the class (particularly the later Walschaerts variants) continued on in secondary roles such as branch-line passenger and goods services and a number lasted into the 1960s. Their last regular mainline duty was hauling services between Flinders Street Station and Leongatha, on the South Gippsland line. The last in service, A2 986, was withdrawn on 2 December 1963, exactly 56 years after the original A2 572 entered service.
Accidents
Some A2 locomotives were unfortunate enough to be involved in major accidents:
Preservation
Only one of the original batch of 125 Stephenson A2 locomotives survives; 1913-built A2 884 is today preserved at the ARHS North Williamstown Railway Museum, along with (Walschaerts) A2 995. The museum notes that A2 884 ran a total 1,002,624 miles (1,613,567 km) and A2 995 a total 1,270,404 miles (2,044,517 km) during their service lives.
A2 996 is preserved in Victorian regional city of Echuca by the town's wharf and A2 964 is preserved in the Melbourne suburb of Reservoir.
A2 986 has been restored to full working order by Steamrail Victoria and now can move under its own steam as of 30 May 2015 and is pending entry into service with Steamrail in 2017.