In conventional landline telephony, a non-dialable toll point or toll station was a lone station or line serving a rural subscriber many miles from the nearest central office. As it had no home telephone exchange and therefore no local calling area, all connections were obtained manually from the long distance operator.
Contents
- Toll stations
- Manual exchanges
- Manual radio links
- Manual mobile and marine
- Other non dialable numbers
- References
These toll stations were one of multiple categories of non-dialable points which could only be reached with assistance from the inward operator at destination. Other non-dialable points included locations reachable only by some form of two-way radio and specific categories of manual service.
As manual services are replaced by automated infrastructure and satellite telephony now reaches the most distant points on the globe, truly non-dialable points are becoming rare.
Toll stations
To reach remote rural locations, telephone companies have been created with as little as one subscriber (the Methodist Episcopal Corporation, established in the 1940s to interconnect a Methodist church in Carmanville, Ontario to Bell Canada's long distance network, was taken over by Bell in 1970).
A similar service was provided in North America using toll stations or "ring downs", individual subscribers who were connected over many miles of landline directly to AT&T long distance with no local calling area. Reachable only with operator assistance, these served points like Deep Springs College in Deep Springs, California (whose telephone number for much of the 1980s remained "Deep Springs Toll Station #2"), far corners of the Nevada or California deserts and a few individual ranches in very remote corners of the Texas Panhandle. In Canada, regional incumbent local exchange carriers (such as Telus in Alberta, MTS in Manitoba or Bell Canada in Ontario and Quebec) provided operator assistance to complete inbound calls to non-dialable points.
Local telephone companies were installing toll stations in distant rural areas as recently as the 1970s. While many of these points have subsequently been moved to conventional dial exchanges, in 1999 just over six hundred toll stations were still in service in the North American Numbering Plan. Many were a lone party line serving some remote hamlet too small for its own telephone exchange. In 1999, more than half of the remaining toll stations were in Canada, with Quebec and Newfoundland the largest users. The remaining US toll stations mostly served rural Nevada, with a handful in California and Oregon.
A request for "TinyVille Toll Station #2" would require the operator call the inbound operator (NPA+121) or a special ringdown operator (NPA+181) at destination, who would ring the one line to "TinyVille" with a specific pattern to signal the second subscriber to answer. The system created operator confusion and was incompatible with equipment based on auto-dial modems, such as automated teller machines. Nevada Bell and GTE replaced the last of their Nevada toll stations with seven-digit dial service in 2001.
These points originally appeared directly in national AT&T or Bellcore routing tables; each would have its own V and H co-ordinates (as toll calls are billed by distance) and a non-dialable number for billing records (initially within the geographic area code, although often in an invalid format like 702-012-3456). The list of non-dialable points was later maintained by NANPA (in the US) and CNAC (in Canada). A pair of area codes (886 and 889), created post-1995 and abolished on July 1, 2003, was used by NANPA and CNAC to list each non-dialable toll point as a rate centre and exchange (a block of 10000 numbers with an associated geographic pair of V/H co-ordinates for billing distance calculation); these codes have since been reclaimed for use as future toll-free numbers.
Manual exchanges
Long after the introduction of local dial service to major cities in the 1920s, 1930s, and 1940s, and the creation of the original 86 North American area codes in 1947, calls to tiny, out-of-the way places required time-consuming setup by multiple manual operators at various intermediate points. As one of many examples, a call from a police sergeant in Los Angeles to a three-digit number in Murphy, Idaho was depicted in the radio version of Dragnet as a two-minute process where the officer dials a local long distance operator, who contacts a rate-and-route operator, then has Boise, Idaho contact Nampa to manually contact an operator in Murphy, who rings the destination subscriber. On a complex manual routing through multiple points, it was standard practice for the operator to ring the original subscriber back once a call was ready.
Not all manual telephone exchanges were non-dialable points. Some were equipped with apparatus which displayed the called number to an operator when an outside call arrived from an automated dial exchange; this panel call indicator or coded-call indicator working would have made them dialable points from other exchanges, despite the absence of local dial.
If a manual exchange did not have call indicator equipment but did have a published numeric exchange prefix, incoming calls from automatic exchanges would be prompted manually with "Number, please?" after the first few digits (or, in fixed-length store-and-forward systems like the UK director exchanges, the entire number) had already been dialed. In adjacent communities, a dial subscriber would often need to call the neighboring community. The directory would often instruct him to dial a single digit, such as seven, which would connect to the incoming manual operator for the neighboring community.
Destinations with numbers in non-standard lengths or formats may have required an operator dial the number or request assistance of an inward operator at destination. Rural party line numbers in manual exchanges were prone to awkward, non-standard numbering schemes like "line 10, two long rings and one short" which were gradually eliminated as the number of parties on a single line was reduced and the manual switchboard replaced by automatic dial equipment.
Manual radio links
Historically, some entire telephone exchanges in remote communities were reachable from the outside world only by shortwave radio. The initial international calls to the Dominion of Newfoundland were made on January 10, 1939 on a Canadian Marconi Company shortwave link through Montréal and required operator assistance even after local calls within St. John's switched to dial in 1948. A similar shortwave radio link joined St. John's to London UK, operated manually. While the original 86 area codes (created in 1947) provided a routing code for operators to dial Montréal (514) or Halifax (902) directly, the operator would have had to ask a Canadian operator to attempt to reach Newfoundland by radio until some time after the April Fools' Day 1949 confederation with Canada.
A similar system continued for many years in Canada's far north; Alma or Val-d'Or were points directly reachable by wire from which calls going further north were at one time carried manually by shortwave radio links. These manual links were gradually rendered obsolete by communications satellites and satellite telephony; even the North Pole, well beyond the reach of geosynchronous satellites, should be within the costly but automated reach of the Iridium satellite constellation.
Manual mobile and marine
The first widespread deployment of automatic mobile telephone service was the Advanced Mobile Phone System, introduced in October 1983 and discontinued in the early 21st century. It, like its successors, is direct-dial. Earlier radio manual mobile systems had a very limited number of mobile channels and required that calls to Mobile Telephone Service and ship-to-shore subscribers be placed via the mobile or marine operator.