KTM 950 Adventure

History

The story of KTM 950 Adventure has started in 1992. That year, a one-off special called the Bepono, built for the German BoTT series by two engineering students by combining a pair of cylinders from a KTM LC4 single on a special crankcase, was displayed on the KTM stand at the IFMA Show in Cologne.

That was just a teaser, though - as was the second time around in 1996, when it was revealed that the Stuttgart-based design office Kraft Technik, had been commissioned by KTM to produce a design for a V-twin Hard Enduro, possibly using the 60-degree V-twin RSV900 Rotax engine at that time developing for Aprilia. The Italian company however refused to share it with their Austrian neighbours. Another alternative for KTM was the Swedish Folan 60-degree V-twin motor which already existed, however it was also aborted once KTM had been successfully floated on the stock market.

In early 1998, as the company grew in strength and the need to expand its single-cylinder range with a twin-cylinder product line, new V-twin became a priority. Chief engineer Wolfgang Felber made preliminary studies of twin-cylinder engine formats and vehicle concepts.

By August 1998 the decision was made to go with a 75-degree V-twin design, but with special emphasis on light weight and, especially, compact build. To do so, KTM decided to assume the entire R&D process themselves in-house, and hired Claus Holweg as Project Manager from their Austrian rivals, Rotax.

The new engine called LC8 was complete and had its first dyno run on August 11, 1999 in exactly 12 months from the start.

After the successful engine development the time came to design the body of 950 Adventure.

Development and management departments of KTM put designers and model makers together to set a concept. The final prototype’s design was complete by Kiska, the design partner of KTM, and presented at Munich Motorcycle show in 2000.

After the critical votes, KTM CEO Stefan Pierer decided to reject the first draft of the Adventure except few small details, chassis and engine.

KTM's designers were innovative in defining a never seen design, strained and broken lines with a very angular fairing. In order to help, engineers asked rally pilot Fabrizio Meoni to assist.

In early 2001, engineers quickly built a frame house with ratings defined by Meoni and soon in February 2001, he begins Adventure testing under the real conditions in Tunisia.

Later that year Fabrizio Meoni wins Rallye des Pharaons 2001 following superior victory on the Dakar in 2002, confirming that 950 Adventure is ready.

The nearly final form of the 950 Adventure was formally presented in at the 2003 Intermot Motorcycle show. Mass production of the LC8 begins in February 2003

Suspension

Front and rear suspensions were made by White Power (WP). Front suspensions (also known as forks) allow compression adjustment at the bottom as well as damping adjustments at the top of the forks. Spring preload can be adjusted by removing the top cap of the forks.

Rear suspension (shock absorber) has rebound adjustment at the bottom of the shock. High/low speed dampening are adjustable using a clicker dial and a 14mm hex at the top. It is worth noting that High/Low speed dampening are referring to speed of compressing the spring, not speed of the motorcycle.

Rear shock on all adventure models of 950 and 990 have hydraulic preload adjustment accessible with a knob on the left side of the motorcycle. KTM 950 Super Enduro version has a mechanical large nut compressing the spring instead.

Suspension Travel

Front and rear suspension were changed by KTM through the years it was in production. Seat heigh and ground clearance were subsequently reduced from 2003 model and new year. Some future models of successor KTM 990 Adventure saw increased suspension travel.