Suvarna Garge (Editor)

Taylor Mill State Historic Site

Updated on
Edit
Like
Comment
Share on FacebookTweet on TwitterShare on LinkedInShare on Reddit
Type
  
State park

Phone
  
+1 603-431-6774

Location
  
Derry, New Hampshire

Taylor Mill State Historic Site

Operated by
  
New Hampshire Division of Parks and Recreation, New Hampshire Division of Forests and Lands

Website
  
Taylor Mill State Historic Site

Address
  
242 Island Pond Rd, Derry, NH 03038, USA

Similar
  
Androscoggin Wayside Park, Rollins State Park, Dixville Notch State Park, Endicott Rock, Ahern State Park

The Taylor Mill State Historic Site is a state park of New Hampshire located in 71-acre Ballard State Forest in Derry, Rockingham County, in the southeast part of the state. The site is created to protect the 1799 mill known as Taylor Up and Down Sawmill. The sawmill is in operation and is open for visitors on weekends during the summer. The site is located on Island Pond Road, east of the downtown of Derry.

Contents

History

Robert Taylor, an early owner of the sawmill, bought the land in 1799. The mill went in operation in the 1800s. It is unknown when it ceased operation. In 1939, the land was sold to Ernest Ballard. By that time, the original mill was scrapped, and Ballard bought a similar mill, which was disassembled, in Sandown, New Hampshire. Ballard and his wife spent two years assembling it and identifying missing parts. The most notable missing part was the water wheel, which he ordered from a company in Pennsylvania. In 1953, Ernest Ballard donated the mill and the land to the state of New Hampshire in 1953. This 71-acre (0.29 km2) property became Ballard State Forest, and the pond above the mill is known as Ballard Pond.

Mill

The water wheel is 12 feet (3.7 m) in diameter and 6 feet (1.8 m) wide.

The logs which can be sawed at the mill can not exceed 10 feet (3.0 m) in length and 28 inches (71 cm) in diameter. The mill operates at 60 strokes per minute. By operation type, the mill is an up and down mill, which is a mechanized version of a usual saw. This is an outdated technology, which was replaced by water-powered circular saw around 1825. Taylor Mill is one of the few examples of a surviving mill using this technology.

References

Taylor Mill State Historic Site Wikipedia