 | ||
In physics, a surface wave is a mechanical wave that propagates along the interface between differing media. A common example is gravity waves along the surface of liquids, such as ocean waves. Gravity waves can also occur within liquids, at the interface between two fluids with different densities. Elastic surface waves can travel along the surface of solids, such as Rayleigh or Love waves. Electromagnetic waves can also propagate as "surface waves" in that they can be guided along along a refractive index gradient or along an interface between two media having different dielectric constants. In radio transmission, a ground wave is a guided wave that propagates close to the surface of the Earth.
Contents
Mechanical waves
In seismology, several types of surface waves are encountered. Surface waves, in this mechanical sense, are commonly known as either Love waves (L waves) or Rayleigh waves. A seismic wave is a wave that travels through the Earth, often as the result of an earthquake or explosion. Love waves have transverse motion (movement is perpendicular to the direction of travel, like light waves), whereas Rayleigh waves have both longitudinal (movement parallel to the direction of travel, like sound waves) and transverse motion. Seismic waves are studied by seismologists and measured by a seismograph or seismometer. Surface waves span a wide frequency range, and the period of waves that are most damaging is usually 10 seconds or longer. Surface waves can travel around the globe many times from the largest earthquakes. Surface waves are caused when P waves and S waves come to the surface.
The term "surface wave" can describe waves over an ocean, even when they are approximated by Airy functions and are more properly called creeping waves. Examples are the waves at the surface of water and air (ocean surface waves), or ripples in the sand at the interface with water or air. Another example is internal waves, which can be transmitted along the interface of two water masses of different densities.
In theory of hearing physiology, the traveling wave (TW) of Von Bekesy, resulted from an acoustic surface wave of the basilar membrane into the cochlear duct. His theory pretended to explain every features of the auditory sensation owing to these passive mechanical phenomena. But Jozef Zwislocki and later David Kemp, showed that that was unrealistic and that active feedback is necessary.
Electromagnetic waves
Ground wave refers to the propagation of radio waves parallel to and adjacent to the surface of the Earth, following the curvature of the Earth. This radiative ground wave is known as the Norton surface wave. Other types of surface wave are the non-radiative Zenneck surface wave or Zenneck-Sommerfeld surface wave, the trapped surface wave and the gliding wave. See also Dyakonov surface waves (DSW) propagating at the interface of transparent materials with different symmetry.
Radio propagation
Lower frequency radio space waves, below 3 MHz, travel efficiently as ground waves. In ITU nomenclature, this includes (in order): medium frequency (MF), low frequency (LF), very low frequency (VLF), ultra low frequency (ULF), super low frequency (SLF), extremely low frequency (ELF) waves.
Ground propagation works because lower-frequency waves are more strongly diffracted around obstacles due to their long wavelengths, allowing them to follow the Earth's curvature. The Earth has one refractive index and the atmosphere has another, thus constituting an interface that supports the guided wave's transmission. Ground waves propagate in vertical polarization, with their magnetic field horizontal and electric field (close to) vertical. With VLF waves, the Ionosphere and earth's surface act as a waveguide.
Conductivity of the surface affects the propagation of ground waves, with more conductive surfaces such as sea water providing better propagation. Increasing the conductivity in a surface results in less dissipation. The refractive indices are subject to spatial and temporal changes. Since the ground is not a perfect electrical conductor, ground waves are attenuated as they follow the earth’s surface. The wavefronts initially are vertical, but the ground, acting as a lossy dielectric, causes the wave to tilt forward as it travels. This directs some of the energy into the earth where it is dissipated, so that the signal decreases exponentially.
Most long-distance LF "longwave" radio communication (between 30 kHz and 300 kHz) is a result of groundwave propagation. Mediumwave radio transmissions (frequencies between 300 kHz and 3000 kHz), including AM broadcast band, travel both as groundwaves and, for longer distances at night, as skywaves. Ground losses become lower at lower frequencies, greatly increasing the coverage of AM stations using the lower end of the band. The VLF and LF frequencies are mostly used for military communications, especially with ships and submarines. The lower the frequency the better the waves penetrate sea water. ELF waves (below 3 kHz) have even been used to communicate with deeply submerged submarines.
Ground waves have been used in over-the-horizon radar, which operates mainly at frequencies between 2 and 20 MHz over the sea, which has a sufficiently high conductivity to convey them to and from a reasonable distance (up to 100 km or more; over-horizon radar also uses skywave propagation at much greater distances). In the development of radio, ground waves were used extensively. Early commercial and professional radio services relied exclusively on long wave, low frequencies and ground-wave propagation. To prevent interference with these services, amateur and experimental transmitters were restricted to the high frequencies (HF), felt to be useless since their ground-wave range was limited. Upon discovery of the other propagation modes possible at medium wave and short wave frequencies, the advantages of HF for commercial and military purposes became apparent. Amateur experimentation was then confined only to authorized frequencies in the range.
Mediumwave and shortwave reflect off the ionosphere at night, which is known as skywave. During daylight hours, the lower D layer of the ionosphere forms and absorbs lower frequency energy. This prevents skywave propagation from being very effective on mediumwave frequencies in daylight hours. At night, when the D layer dissipates, mediumwave transmissions travel better by skywave. Ground waves do not include ionospheric and tropospheric waves.
The propagation of sound waves through the ground taking advantage of the earths ability to more efficiently transmit low frequency is known as Audio ground wave (AGW).
Microwave field theory
Within microwave field theory, the interface of a dielectric and conductor supports "surface wave transmission". Surface waves have been studied as part of transmission lines and some may be considered as single-wire transmission lines.
Characteristics and utilizations of the electrical surface wave phenomenon include:
Surface plasmon polariton
The surface plasmon polariton (SPP) is an electromagnetic surface wave that travels along an interface between two media with different dielectric constants. It exists under the condition that the permittivity of one of the materials forming the interface is negative, while the other one is positive, as is the case for the interface between air and a lossy conducting medium below the plasma frequency. The wave propagates parallel to the interface and decays exponentially vertical to it, a property called evanescence. Since the wave is on the boundary of a lossy conductor and a second medium, these oscillations can be sensitive to changes to the boundary, such as the adsorption of molecules by the conducting surface.
Sommerfeld-Zenneck surface wave
The Sommerfeld-Zenneck wave or Zenneck wave is a non-radiative guided electromagnetic wave that is supported by a planar or spherical interface between two homogeneous media having different dielectric constants. This surface wave propagates parallel to the interface and decays exponentially vertical to it, a property known as evanescence. It exists under the condition that the permittivity of one of the materials forming the interface is negative, while the other one is positive, as for example the interface between air and a lossy conducting medium such as the terrestrial transmission line, below the plasma frequency. Arising from original analysis by Arnold Sommerfeld and Jonathan Zenneck of the problem of wave propagation over a lossy earth, it exists as an exact solution to Maxwell's equations.