In service 1925-1930 Rebuilder South African Railways | Rebuilt from Type HT | |
 | ||
Locomotive Class 15C, Class 15CA, Class 16D, Class 16DA Designer Baldwin Locomotive Works Builder American Locomotive Company
Baldwin Locomotive Works
Henschel and Son
Hohenzollern Locomotive Works
Società Italiana Ernesto Breda
North British Locomotive Company | ||
The South African type KT tender was a steam locomotive tender.
Contents
The Type KT tender first entered service in 1925, as tenders to the Class 15CB Big Bill 4-8-2 Mountain type and Class 16D Big Bertha 4-6-2 Pacific type steam locomotives which were acquired by the South African Railways in that year.
Manufacturers
Type KT tenders were built between 1925 and 1930 by American Locomotive Company, Baldwin Locomotive Works, Henschel and Son, Hohenzollern Locomotive Works, Società Italiana Ernesto Breda and North British Locomotive Company.
The South African Railways (SAR) placed twelve Class 15C Mountain type locomotives (reclassified to Class 15CB in 1926) and seven Class 16D Pacific type locomotives in service in 1925 and 1926. The locomotives and tender were designed by Baldwin Locomotive Works of Philadelphia. The Classes 15C and 16D were acquired specifically for the long runs of the Union Limited (Johannesburg to Cape Town) and Union Express (Cape Town to Johannesburg) passenger trains. The Type KT first entered service as tenders to these two locomotive Classes.
Characteristics
The tenders were arranged with self-trimming type coal bunkers and had a maximum coal capacity of 14 long tons (14.2 tonnes) and a maximum water capacity of 6,000 imperial gallons (27,300 litres), which was considered sufficient for the engines to travel 100 miles (161 kilometres) without having to replenish water.
The water capacity of the tenders were described in official SAR diagrams as "nominal", while three coal capacities of 12, 13 and 14 long tons (12.2, 13.2 and 14.2 tonnes) were shown. This appears to have been limitations for working on lines laid with lighter rail after the respective engines were withdrawn from mainline working, since the tenders were apparently not modified to reduce their capacities. The instruction was that water capacity (water taken) was to be reduced where necessary to ensure that the respective maximum axle loads of 16 long tons 11 hundredweight (16,820 kilograms), 16 long tons 17 hundredweight 2 quarters (17,150 kilograms) and 17 long tons 15 hundredweight (18,030 kilograms), as shown in the diagrams with the three given coal loads, were not exceeded.
Locomotives
Five locomotive classes and models, built by six manufacturers, were delivered new with Type KT tenders, which were numbered for their engines in the number ranges as shown. An oval number plate, bearing the engine number and often also the tender type, was attached to the rear end of the tender. On some tenders, presumably after number plates went astray, the number was weld-written on the tender instead, as on the illustrated tender no. 2041.
Classification letters
Since many tender types are interchangeable between different locomotive classes and types, a tender classification system was adopted by the SAR. The first letter of the tender type indicates the classes of engines to which it can be coupled. The "K_" tenders could only be used with the four locomotive classes with which they were delivered.
The second letter indicates the tender's water capacity. The "_T" tenders had a capacity of between 5,587 and 6,000 imperial gallons (25,400 and 27,300 litres; 6,710 and 7,210 US gallons).
Modified from Type HT
After their locomotives were withdrawn from service, the Type HT tenders of the two Class 18 2-10-2 Henschel Giants had their mechanical stokers removed and their drawgear modified for use with Class 15CA locomotives. These two tenders were then redesignated Type KT as well.