Kalpana Kalpana (Editor)

Riegelsville Bridge

Updated on
Edit
Like
Comment
Share on FacebookTweet on TwitterShare on LinkedInShare on Reddit
Carries
  
Delaware Road

Design
  
Suspension bridge

Opened
  
1904

Bridge type
  
Suspension bridge

Carry
  
Delaware Road

Crosses
  
Delaware River

Total length
  
176 m

Location
  
Pohatcong Township

Body of water
  
Delaware River

Riegelsville Bridge

Locale
  
Pohatcong Township, New Jersey, and Riegelsville, Pennsylvania

Maintained by
  
Delaware River Joint Toll Bridge Commission

Address
  
Phillipsburg, NJ 08865, USA

Similar
  
Riverton–Belvidere Bridge, Upper Black Eddy–Milf, Northampton Street Bridge, Centre Bridge–Stockton Bridge, Portland–Columbia Toll Bridge

Riegelsville bridge westbound


The Riegelsville Bridge is a suspension bridge crossing the Delaware River at Riegelsville, Pennsylvania, connecting it with Pohatcong Township, New Jersey, United States.

Contents

Riegelsville bridge and delaware river time lapse


History

Traffic across the Delaware River at Riegelsville, Pennsylvania, was handled by Wendel and Anthony Shenk's oar powered ferries until December 15, 1837, when a three-span, wooden covered bridge was opened to horse, wagon, and pedestrian use. The Pennsylvania and New Jersey legislatures had approved the formation of the private Riegelsville Delaware Bridge Corporation in 1835 and the company engaged Solon Chapin and James Madison Porter of Easton, Pennsylvania as the contractors. A major flood struck the Delaware Valley on January 8, 1841, just three years after the bridge opened, and the span nearest the Jersey shore was destroyed. The bridge was repaired and survived another flood in June 1862.

The "Pumpkin Flood" occurred on October 10, 1903, and the Delaware waters rose to 33.8 feet (10.3 m) above normal. The two spans nearest to New Jersey were quickly swept down the river. The third section collapsed soon after.

The wire rope and engineering firm of John A. Roebling's Sons Co., based in Trenton, New Jersey, were soon commissioned and replaced the covered bridge with a cable suspension bridge. This new bridge incorporated the original piers which were repaired and raised several feet, allowing it to survive major damage from the flood of 1936 and to come through a 1955 deluge relatively unscathed. Together, the three spans are 585 feet (178 m) in length and the final cost of construction was $30,000. It opened on April 18, 1904.

Roebling's original design for the bridge employed main cables 2 58 inches (7 cm) in diameter. Professor James Madison Porter III, the grandson of the builder of the earlier Riegelsville bridge, was asked to evaluate the new design and felt the need for additional cables of 1 34 inches (4 cm) diameter, which were added to the plans.

The Riegelsville suspension bridge collected tolls until it was purchased by the Joint Commission for Eliminating Tolls and is currently maintained by the Delaware River Joint Toll Bridge Commission using revenues generated from larger, more heavily trafficked crossings. The bridge has a 3-ton weight limit.

References

Riegelsville Bridge Wikipedia