Kalpana Kalpana (Editor)

RNLB Ruby and Arthur Reed (ON 990)

Updated on
Edit
Like
Comment
Share on FacebookTweet on TwitterShare on LinkedInShare on Reddit
Official Number
  
ON 990

Cost
  
£60,000

Weight
  
30 tons

Draft
  
1.35 m

Station
  
Launched
  
1966

Displacement
  
30,000 kg

Builder
  
RNLB Ruby and Arthur Reed (ON 990) httpsuploadwikimediaorgwikipediacommonsthu

Donor
  
Gift of Mrs R. M. Reed, Eastbourne, in memory of her Husband of Stanford

Ruby and Arthur Reed (RNLI Official Number 990) was an Oakley-class lifeboat of the Royal National Lifeboat Institution (RNLI) stationed at Cromer in the English county of Norfolk from the 30 April 1967 and was the No 1 lifeboat between various relief’s until she was replaced after 17 years service by the Tyne-class Ruby and Arthur Reed II on the 16 December 1985. During the time that the Ruby and Arthur Reed was on station at Cromer she performed 125 service launches, rescuing 58 lives.

Contents

Design and construction

Ruby and Arthur Reed was built in 1966 at the yard of William Osborne at Littlehampton, West Sussex. She was an Oakley class self-righting design which combined great stability with the ability to self-right in the event of the lifeboat capsizing. This was achieved by a system of shifting water ballast. The system worked by the lifeboat taking on one and half tons of sea water at launching in to a tank built into the base of the hull. If the lifeboat then reached a crucial point of capsize the ballast water would transfer through valves to a righting tank built into the port side. If the capsize was to the starboard side of the lifeboat, the water shift started when an angle of 165° was reached. This would push the boat into completing a full 360° roll. If the capsize was to the port side, the water transfer started at 110°. In this case the weight of water combined with the weight of machinery aboard the lifeboat usually managed to stop the roll and allow the lifeboat to bounce back to upright.

Hull construction

The hull of the Ruby and Arthur Reed was constructed from African mahogany built with two skins. Each skin was diagonally laid with a layer of calico laid between the skins. The outer skin was ⅜ of an inch thick with the inner skin being ¼ of an inch thick. The keel was iron and weighed 1.154 tons. The hull was divided into eleven watertight compartments. The lifeboat was 48 feet 6 inches (14.78 m) in length and 14 feet 0 inches (4.27 m) in beam and displaced 12 tons 1cwt, when fully laden with crew and gear. She was fitted with twin 110 hp Gardner 6LX six cylinder diesel engines, which moved her over the water at 9 Knots. Ruby and Arthur Reed’s aluminium wheelhouse was positioned amidships and was fully enclosed which provided welcome crew protection from the elements. Aft of the lifeboat there was another cabin which served as the chartroom and also housed all the lifeboats electronic equipment.

Equipment

The lifeboat was fitted with Decca 060 radar and all she carried Pye Westminster VHF and an Ajax MF Radiotelephone. In addition a radio Direction Finding set was carried, which gave a magnetic bearing to a transmitting station. The electric searchlight was standard along with Pains Wessex speedlines.

Service

Ruby and Arthur Reed was on station at Cromer for seventeen years and during that time she was launched 125 times and she saved fifty eight lives. Her first service took place on the Fourth of July 1967 to a motor fishing vessel called Renovate. The fishing boat’s engine had failed and she was at anchor two miles east of Haisborough Sands. Two engineers from the Royal Naval minesweeper HMS Belton were put aboard to try to repair her. Coxswain Henry Shrimp Davies and his Lifeboat stood by through the night until the boats engines were once again working.

References

RNLB Ruby and Arthur Reed (ON 990) Wikipedia


Similar Topics