Crosses Mississippi River Total length 6,442 ft (1,964 m) Construction started February 1868 Height 27 m Architect James Buchanan Eads | Design Arch bridge Address St. Louis, MO 63102, USA Opened 4 July 1874 Engineer James Buchanan Eads Location St. Louis, East St. Louis | |
 | ||
Carries 4 highway lanes
2 MetroLink tracks Locale St. Louis, Missouri and East St. Louis, Illinois Other name(s) World's First All Steel Bridge Similar Poplar Street Bridge, Jefferson National Expansio, Gateway Arch, Martin Luther King Bridge, Chain of Rocks Bridge | ||
C span cities tour st louis historic eads bridge
Eads Bridge is a steel technology combined road and railway bridge over the Mississippi River at St. Louis, connecting St. Louis and East St. Louis, Illinois. Opened in 1874, it was one of the earliest long bridges built across the Mississippi, the world' first all steel construction, and built high enough so steamboats could travel under. As such, the St. Louis Landmark is listed on the National Register of Historic Places, as a National Historic Landmark. As of April 2014, it carries about 8,100 vehicles daily, down 3,000 since the new Stan Musial Veterans Memorial Bridge opened in February 2014.
Contents
The bridge is named for its designer and builder, James B. Eads. When completed in 1874, the Eads Bridge was the longest arch bridge in the world, with an overall length of 6,442 feet (1,964 m). The ribbed steel arch spans were considered daring, as was the use of steel as a primary structural material: it was the first such use of true steel in a major bridge project. The cost of building the bridge was nearly $10 million.
The Eads Bridge was also the first bridge to be built using cantilever support methods exclusively, and one of the first to make use of pneumatic caissons. The Eads Bridge caissons, still among the deepest ever sunk, were responsible for one of the first major outbreaks of "caisson disease" (also known as "the bends" or decompression sickness). Fifteen workers died, two other workers were permanently disabled, and 77 were severely afflicted.
On June 14, 1874, John Robinson led a "test elephant" on a stroll across the new Eads Bridge to prove it was safe. A big crowd cheered as the elephant from a traveling circus lumbered towards Illinois. It was believed that elephants had instincts that would keep them from setting foot on unsafe structures. Two weeks later, Eads sent 14 locomotives back and forth across the bridge at one time. The opening day celebration on July 4, 1874, featured a parade that stretched 15 miles (24 km) through the streets of St. Louis.
The Eads Bridge, which became an iconic image of the city of St. Louis, from the time of its erection until 1965 when the Gateway Arch was constructed, is still in use. The bridge crosses the St. Louis riverfront between Laclede's Landing, to the north, and the grounds of the Gateway Arch, to the south. Today the road deck has been restored, allowing vehicular and pedestrian traffic to cross the river. The St. Louis MetroLink light rail system has used the rail deck since 1993.
The eads bridge
History
The Eads Bridge was built by the Illinois and St. Louis Bridge Company, with the Keystone Bridge Company serving as subcontractor for superstructure erection.
The domination of the river trade was no longer as important as before the American Civil War, and Chicago was fast gaining as the center of commerce in the West. The bridge was conceived as a solution for St. Louis to regain eminence by connecting transportation across the river. Although he had no prior experience in bridge building, James Eads was chosen as chief engineer for the bridge.
In an attempt to secure their future, steamboat interests successfully lobbied to place restrictions on bridge construction, requiring spans and heights previously unheard of. Ostensibly this would maintain sufficient operating room for steamboats beneath the bridge’s base for the then foreseeable future. The unproclaimed purpose was to require a bridge so grand and lofty that it would be impossible to erect according to conventional building techniques. The steamboat parties planned to prevent any structure from being built, in order to ensure continued dependence on river traffic to sustain commerce in the region.
Such a bridge required a radical design solution. The Mississippi River's current was almost 12 1⁄2 feet per second (3.8 m/s) and the builders had to battle ice floes in the winter. The ribbed arch had been a known construction technique for centuries. The triple span, tubular metallic arch construction was supported by two shore abutments and two mid-river piers. Four pairs of arches per span (upper and lower) were set eight feet (2.4 m) apart, supporting an upper deck for vehicular traffic and a lower deck for rail traffic.
Construction involved varied and confusing design elements and pressures. State and federal charters precluded suspension or draw bridges, or wood construction. There were constraints on span size and the height above the water line. The location dictated reconciling differences in heights from the low Illinois floodplain of the east bank to the high Missouri cliff on the west bank of the river. The bedrock required deep drilling to reach, as it was 38 m below water level on the Illinois side and 26 m below on the Missouri side.
These pressures resulted in a bridge noted as innovative for precision and accuracy of construction and quality control. This was the first use of structural alloy steel in a major building construction, through use of cast chromium steel components. The completed bridge also relied on significant—and unknown—amounts of wrought iron. Eads argued that the great compressive strength of steel was ideal for use in the upright arch design. This decision resulted from a curious combination of chance and necessity, due to the insufficient strength of alternative material choices.
The particular physical difficulties of the site stimulated interesting solutions to construction problems. The deep caissons used for pier and abutment construction signaled a new chapter in civil engineering. Piers were sunk almost 100 feet (30 m) below the river's surface. Unable to construct falsework to erect the arches, because they would obstruct river traffic, Eads's engineers devised a cantilevered rigging system to close the arches.
Masonry piers were built to heights of almost 120 feet (37 m), about the height of a ten-story building. About 78 feet (24 m) of that span was driven through the sandy riverbed until it hit bedrock. Eads implemented a building method that he had observed in Europe, whereby masonry was set atop a metal chamber filled with compressed air. Stone was added to the chamber, which caused the caisson to sink. Workers then dove into the caisson to shovel sand into a pump that shot it out into the air so the masonry could be sunk into the riverbed. Thirteen men died during this process and two were paralyzed, suffering from what we now know as the bends. Still today, the Eads Bridge is built on the deepest pneumatic caisson ever constructed.
Eads Bridge was recognized as an innovative and exciting achievement. Eads' secured 47 patents during his lifetime, many of which were taken out for parts of the bridge's structure and devices for its construction. President Ulysses S. Grant dedicated the bridge on July 4, 1874, and General William T. Sherman drove the gold spike completing construction. After completion, 14 locomotives crossed the bridge to prove its stability.
The Eads Bridge was undercapitalized during construction and burdened with debt. With its focus on the river, St. Louis had a lack of adequate rail terminal facilities, and the bridge was poorly planned to coordinate rail access. An engineering and aesthetic success, the bridge was bankrupt within a year of opening. The railroads boycotted the bridge, resulting in a loss of tolls. The bridge was later sold at auction for 20 cents on the dollar. This sale caused the National Bank of the State of Missouri to fold, which was the largest bank failure in the United States at that time. Eads himself did not suffer financial consequences. Many involved with financing the bridge were indicted, but Eads was not.
Granite for the bridge came from the Iron County, Missouri, quarry of Missouri Governor and U.S. Senator B. Gratz Brown who had helped secure federal financing for the bridge.
In 1949, the bridge's strength was tested with electromagnetic strain gauges. It was determined that Eads' original estimation of an allowable load of 3,000 pounds per foot (4,500 kg/m) could be raised to 5,000 pounds per foot (7,400 kg/m). The Eads Bridge is still considered one of the greatest bridges ever built.
The Merchants Exchange eventually lost ownership to the Terminal Railroad Association of St. Louis (TRRA). The Exchange, fearing a Terminal Railroad rail monopoly on the bridges, would then build the Merchants Bridge, which in turn would eventually be taken over by the Terminal Railroad. The Terminal Railroad transferred the bridge to the City of St. Louis in 1989 in exchange for the MacArthur Bridge.
Eads Bridge had long hosted only passenger trains on its rail deck. By the 1970s, the TRRA had abandoned its Eads trackage, as the bridge had lost all remaining passenger rail traffic to the MacArthur Bridge during the early years of Amtrak; the dimensions of modern passenger diesels were incompatible with both the bridge and the adjoining tunnel linking the Union Station trackage with Eads.
In 1998, the Naval Facilities Engineering Service Center investigated the effects of the ramming of the bridge by the barge Anne Holly on April 4 of that year. The ramming resulted in the near breakaway of the SS Admiral, a riverboat casino; several recommended changes reduced the odds of this happening in the future.
Recognition
In 1898 the bridge appeared on the $2 Trans-Mississippi Issue of postage stamps. One hundred years later the design was reprinted in a commemorative souvenir sheet.
The bridge was designated a National Historic Landmark in 1964, recognizing its innovations in design, materials, construction methods, and importance in the history of large-scale engineering projects.
On the bridge's 100th anniversary, the New York Times architectural critic, Ada Louise Huxtable, called it "among the most beautiful works of man."