 | ||
Calendering is a finishing process used on cloth, paper, or plastic film. A calender is employed, usually to smooth, coat, or thin a material.
Contents
With textiles, fabric is passed under rollers at high temperatures and pressures. Calendering is used on fabrics such as moire to produce its watered effect and also on cambric and some types of sateens.
In preparation for calendering, the fabric is folded lengthwise with the front side, or face, inside, and stitched together along the edges. The fabric can be folded together at full width, however this is not done as often as it is more difficult. The fabric is then run through rollers that polish the surface and make the fabric smoother and more lustrous. High temperatures and pressure are used as well. Fabrics that go through the calendering process feel thin, glossy and papery.
The wash durability of a calendared finish on thermoplastic fibres like polyester is higher than on cellulosic fibres such as cotton. On blended fabrics such as Polyester/Cotton the durability depends largely on the proportion of synthetic fibre component present as well as the amount and type of finishing additives used and the machinery and process conditions employed.
Variations
Several different finishes can be achieved through the calendering process by varying different parts. The main different types of finishes are beetling, watered, embossing and Scheiner.
Beetled
Beetling is a finish given to cotton and linen cloth, and makes it look like satin. In the beetling process the fabric goes over wooden rollers and is beaten with wooden hammers.
Watered
The watered finish, also known as moire, is produced by using ribbed rollers. These rollers compress the cloth and the ribs produce the characteristic watermark effect by moving aside threads as well as compressing them. This leaves some of the threads round while others get compressed and become flat.
Embossed
In the embossing process the rollers have engraved patterns on them, and the patterns become stamped onto the fabric. The end result is a raised or sunken pattern, depending on the roller. This works best with soft fabrics.
Schreiner
Similar to the watered process, in the Schreiner process the rollers are ribbed, only in the Schreiner process the ribs are very fine, with as many as six hundred ribs per inch under extremely high pressure. The threads are pressed flat with little lines in them, which causes the fabric to reflect the light better than a flat surface would. Cloth finished with the Schreiner method has a very high lustre, which is made more lasting by heating the rollers.