Puneet Varma (Editor)

Slingsby Motor Tutor

Updated on
Edit
Like
Comment
Share on FacebookTweet on TwitterShare on LinkedInShare on Reddit
Wingspan
  
13 m

Manufacturer
  
Slingsby Aviation

First flight
  
1948

Slingsby Motor Tutor httpsuploadwikimediaorgwikipediacommonsthu

Slingsby motor tutor


The Slingsby T.29 Motor Tutor was a single-seat motor glider produced from 1948, by Slingsby Sailplanes in Kirbymoorside, Yorkshire.

Contents

Design and development

Utilising the wings, struts and tail unit of the T.8 Kirby Tutor, the T.29 Motor Tutor had a new fuselage incorporating a wheeled undercarriage and the cockpit under the wing centre section. Early trials revealed resonance of the front wing struts, which was rectified by adding a vertical bracing strut vertically up to the mainspar. This modification was introduced for all Kirby Tutors to allow aero-tow launching.

Development

Two versions of the T.29 Motor Tutor were produced, T.29A with a 25h.p. Scott Flying Squirrel engine and the T.29B with a 40 h.p. Aeronca JAP J.99. Both of these versions flew successfully but considerable difficulty was had certificating the aircraft with the Air Registration Board, which precluded production. The T.29A was exported and the T.29B crashed at Dunstable in 1964. In 1966 an additional T.29 was discovered by R.G. Boyton at Epsom in Surrey, and is stored pending restoration.

Specifications (T.29A)

General characteristics

  • Crew: One
  • Wingspan: 43 ft 334 in (13.24 m)
  • Wing area: 170 ft2 (15.8 m2)
  • Aspect ratio: 11.1
  • Wing profile: Göttingen 426
  • Powerplant: 1 × Scott Squirrel, 25 hp (18.64 kW)
  • Performance

  • Maximum glide ratio: 16:1
  • References

    Slingsby Motor Tutor Wikipedia