Wingspan 11 m First flight July 26, 1973 | Length 12 m | |
 | ||
The Sikorsky S-69 was an experimental co-axial compound helicopter developed by Sikorsky Aircraft as the demonstrator of the Advancing Blade Concept (ABC) under US Army and NASA funding.
Contents
Development
Also known by the military designation XH-59, the S-69 was the demonstrator for the Advancing Blade Concept (ABC).
The first S-69 built (73-21941) first flew on July 26, 1973. However, it was badly damaged in a crash on August 24, 1973. The airframe was then converted into a wind tunnel testbed, which was tested in the NASA Ames Research Center 40x80 feet full-scale wind tunnel in 1979. A second airframe was completed (73-21942) which first flew on July 21, 1975. After initial testing as a pure helicopter, auxiliary turbojets were added in March 1977. As a helicopter, the XH-59A demonstrated a maximum level speed of 156 knots (289 km/h; 180 mph), but with the auxiliary turbojets, it demonstrated a maximum level speed of 238 knots (441 km/h; 274 mph) and eventually a speed of 263 knots (487 km/h; 303 mph) in a shallow dive. At 180 knots (333 km/h; 207 mph) level flight, it could enter a 1.4g bank turn with the rotor in autorotation, increasing rotor rpm. Airframe stress prevented rotor speed reduction and thus full flight envelope expansion. The XH-59A had high levels of vibration.
The 106-hour test program for the XH-59A ended in 1981. In 1982 it was proposed that the XH-59A be converted to the XH-59B configuration with advanced rotors, new powerplants (two GE T700s), and a ducted pusher propeller at the tail. This proposed program did not proceed as Sikorsky refused to pay a share of the costs. Sikorsky and its partners funded the development of the next helicopters using the Advancing Blade Concept; the Sikorsky X2 and Sikorsky S-97 Raider after 2007.
Airframe 73-21941 is in storage at the NASA Ames Research Center and 73-21942 is on display at the Army Aviation Museum, Fort Rucker, Alabama.
Design
The Advancing Blade Concept system consisted of two rigid, contra-rotating rotors (30 inches apart) which made use of the aerodynamic lift of the advancing blades. At high speeds, the retreating blades were offloaded, as most of the load was supported by the advancing blades of both rotors and the penalty due to stall of the retreating blade was thus eliminated. This system did not require a wing to be fitted for high speeds and to improve maneuverability, and also eliminated the need for an anti-torque rotor at the tail. Forward thrust was provided by two turbojets, which allowed the main rotor to only be required to provide lift. It was found to have good hover stability against crosswind and tailwind. With jets installed, it lacked power to hover out of ground effect and used short take-off and landing for safety reasons.
Specifications (S-69)
Data from U.S. Army Aircraft Since 1947, Illustrated Encyclopedia, US Army Research Laboratory
General characteristics
345 rotor rpm
Performance