When looking at the electronic market it becomes obvious, as there is a need for production output, high system performance, product reliability and long lifecycle, for Microelectromechanical systems(MEMS) to create trust in the eyes of customers. If those conditions would not be met customers would not invest into technologies using MEMS, which justifies the need for testing as a part of a high quality standard.
Contents
Testing is also fairly important from an economical point of view. As it is said that the failure cost increase by a factor of ten for each stage before it gets discovered. Most MEMS producers check their products at two distinct stages(at the wafer level, and the packaging), as well as random sampling on every stage. If one includes this into cost calculation for a MEMS device the costs for testing amounts to 20-50% of the overall unit costs. Even when looking at producers that manufacture MEMS, and CMOS devices it is not really possible to reduce the costs by including the economy of scopes effect for testing, as both types of device. This is because even though about 80% of the processing is shared, only 20% of the tests are. To decrease these costs for U.S manufactures the National Institute of Standards and Technologies(NIST) conducted several workshops and questionnaires to tackle this issue and increase competitiveness of US companies.
What is tested?
Due to the wide variety of MEMS it is hard to be very specific as of what is tested the table below shows what is tested in general:
Different technologies
To test MEMS researchers came up with a wide variety of techniques that can display certain values. However, there is no single technology that can cover all; each has strengths as well as weaknesses.
Below is a list with all major and some minor technologies employed in MEMS testing:
Following technologies were experimented with but are no longer considered for MEMS testing:
All these technologies have strengths and weaknesses, so in order to maximize the effectiveness of test equipment researchers combined technologies. For instance Christian Rembe, former researcher at UC Berkley, combined laser doppler vibrometry, white light interferometry and strobe video microscopy into one tool to eliminate each technologies weakness.