Harman Patil (Editor)

Industrial dye degradation

Updated on
Share on FacebookTweet on TwitterShare on LinkedInShare on Reddit
Covid-19
Industrial dye degradation

Synthetic dyes are found in a wide range of products such as clothes, leather accessories, and furniture. These dyes are commonly used every day. However, a side effect of their widespread use is that up to 12% of these dyes are wasted during the dying process and about 20% of this wastage enters the environment (mainly into water supply).

Contents

Dye degradation is a process in which the large dye molecules are broken down chemically into smaller molecules. The resulting products are water, carbon dioxide, and mineral byproducts that give the original dye its color. During the dyeing process, not all of the dye molecules are used. The water waste that the industry releases contains a percentage of these dye molecules. Dye molecules persist in the environment because many of them are not reactive towards light, acids, bases and oxygen. The color of the material becomes permanent.

Photocatalysis

Heterogeneous photocataylsis is a widely accepted technique of choice for environmental purification. The standard experimental set up for dye degradation photocatalysis is by using a UV lamp to provide energy for the creation of oxidizing radicals. Photocatalysis is the addition of light to a semiconductor oxide/sulphide that results in electrons moving from the valence band to the conduction band. The electron-hole pairs formed will react with oxygen and water molecules to create superoxide anions and hydroxide radicals that have increased oxidizing and reducing abilities to be used on numerous industrial dye compounds.

6,13-Pentacenequinone/ Titanium Dioxide

Titanium dioxide (TiO2) is biologically stable, non-toxic, and cheap, which makes it a very common semiconductor for dye degradation. Due to its large band gap, some alterations can be made to improve its photocatalytic abilities such as the synthesis of 6,13-pentacenequinone/ TiO2. Titanium dioxide in conjunction with ultraviolet light can be utilized for the decolorization and detoxification of diluted colored water waste such as Alizarin, azo dyes, methyl red, methylene blue, etc. Reduced graphene oxide-TiO2 can act as photocatalyst for the degradation of methyl orange, azo-dye, and pharmaceutical water waste.

CuS

3-D structures of copper sulfide (CuS) is favored for methylene blue degradation because it is nontoxic, inexpensive, and stable under ambient conditions. It has efficient catalytic ability because of its high surface area to volume ratio allowing for better contact between the reactants and CuS.

Graphitic Carbon Nitride

Hierarchically porous graphitic carbon nitride (hp-g-CN) had a 90% photodegradation of methyl orange, which is an improvement over other commercial photocatalysts. This is due to a higher surface area for an increased absorption capacity and porous features that allow for an increased diffusion of methyl orange.

Fenton Process

The Fenton process utilizes iron catalysts with H2O2 to create powerful, oxidizing hydroxides for the degradation of organic pollutants such as sewage and sludge as well as dyes. To enhance the catalytic abilities, a combination of Fe2+ cations, ultraviolet light, and hydrogen peroxide can be used and has shown greater removals of dye solutions.

Biomass

Biomass degradation refers to the utilization of microorganisms such as bacteria and fungi to produce enzymes that can interact with molecules of dyes. Laccases are proteins that are produced by Lentinus sp; its active site contains a group of polyphenol oxidases incorporated with four copper ions. These can form hydrogen bonds with synthetic dyes. The efficiency of this enzyme is proportional to the number of hydrogen bonds that form between the enzyme and dyes. Microorganisms are easy to manipulate, but the efficiency is highly dependent on the pH, ionic strength, and temperature. This will be varied with different effluents. Effluents can be first processed by a strain of yeast Candida tropicalis JKS2 then post-treated by photocatalytic processes to degrade the aromatic rings so a cost-effective outcome can be achieved. Immobilized fungal cells are more resistant to environmental stress and cells can be used repeatedly.

Hazards

Many dyes, specifically in the textile industry such as methylene blue or methyl red, are released into ecosystems through water waste. Many of these dyes can be carcinogenic and can come into contact with humans. As a result, newer treatments of the water waste are still in development.

References

Industrial dye degradation Wikipedia


Similar Topics
Home from Home (1939 film)
Jamie Bulloch
Shailesh Kumar Mandal
Topics
 
B
i
Link
H2
L