Drift boat

Boat Hull Materials

The earliest drift boats were made out of various types of wood. Later boats were made with lower maintenance materials like aluminum, fiberglass, or plastic.

In 1992 the film "A River Runs Through It" featured a wooden drift boat running "the shoots", a series of rapids (filmed in Montana ). This portrayal of using drift boats in class I -IV rapids is only one application for this unique watercraft. Today river fishing is among the major uses of these boats. Innovation has changed the design from anglers primarily sitting in the boat while fishing, to today's application of anglers standing in a leg brace to fish.

Rogue River dory

The Rogue River dories are completely flat on the bottom with upward rakes under the prow and the stern unlike the McKenzie boats. The Rogue River guides needed a boat with greater carrying capacity, and the ability to hold the current. The Rogue River dory is not quite as responsive as the McKenzie River dory but is typically larger than the McKenzie dory and is used where many people and large amounts of gear need to be carried. The high prow, great carrying capacity, and ease of rowing makes it the preferred dory for commercial use. The classic Rogue River dory with a nearly full deck is a favorite among guides on the Colorado River, while on the same river, the decked McKenzie River dory has a large following among do-it-yourself river runners.

Cajune Drift Boats

Cajune Boats is a custom manufacturer of wooden drift boats in Montana. The business is owned by Jason Cajune and the paddle fishing boats, including the Kingfisher, are produced with his wife and two daughters in his Paradise Valley, Montana home near the Yellowstone River. Fiberglass, epoxy and modern technology are incorporated into the boat designs.

The riverboats are produced in a style known as McKenzie, a traditional wooden dory design that originated circa 300 A.D. "for surf and inshore fishing boats on the Arabian Sea". They are flat bottomed and manage a heavy load well. They are made for rough water and rapids. Pat Barnes is credited with bringing them to Montana around 1950.

Cajune studied architecture, engineering, and filmed media at Montana State University in Bozeman before departing to work as a boat builder in Washington State. He returned to Montana in 1996 with his wife and established Montana Boatbuilders. The business builds about 20-24 boats a year, and waits for new orders can be up to two years. The business also performs repairs on boats madebuilders except in aluminum.

McKenzie Dories

McKenzie dories are specialized to run rapids on rivers, and first appeared on the McKenzie River in Oregon in the mid-20th century. They have a wide flat bottom for low draft, a narrow bow that is flat, often mistaken for the transom, which instead is pointed. The reason for this is that the rower faces downstream, therefore the part of the boat which first hits the waves (approaching from behind) must be pointed or very narrow to throw the water to the side. The bow is then widened so that a small outboard motor and/or anchor bracket can be attached. Those unfamiliar with the craft would say that they are rowed backwards. McKenzie dories without a transom are called "double-enders". McKenzie River dories are mainly used by recreational boaters who wish to operate a very responsive boat. Like the Rogue River boats described below, the McKenzie River dory provides a much more responsive boating experience than that of a rubber raft. While the McKenzie River dory is a safe watercraft, operating any dory requires keeping river conditions in mind at all times.