Delayed choice quantum eraser

Introduction

In the basic double slit experiment, a beam of light (usually from a laser) is directed perpendicularly towards a wall pierced by two parallel slit apertures. If a detection screen (anything from a sheet of white paper to a CCD) is put on the other side of the double slit wall, a pattern of light and dark fringes will be observed, a pattern that is called an interference pattern. Other atomic-scale entities such as electrons are found to exhibit the same behavior when fired toward a double slit. By decreasing the brightness of the source sufficiently, individual particles that form the interference pattern are detectable. The emergence of an interference pattern suggests that each particle passing through the slits interferes with itself, and that therefore in some sense the particles are going through both slits at once. This is an idea that contradicts our everyday experience of discrete objects.

A well-known thought experiment, which played a vital role in the history of quantum mechanics (for example, see the discussion on Einstein's version of this experiment), demonstrated that if particle detectors are positioned at the slits, showing through which slit a photon goes, the interference pattern will disappear. This which-way experiment illustrates the complementarity principle that photons can behave as either particles or waves, but not both at the same time. However, technically feasible realizations of this experiment were not proposed until the 1970s.

Which-path information and the visibility of interference fringes are hence complementary quantities. In the double-slit experiment, conventional wisdom held that observing the particles inevitably disturbed them enough to destroy the interference pattern as a result of the Heisenberg uncertainty principle.

However, in 1982, Scully and Drühl found a loophole around this interpretation. They proposed a "quantum eraser" to obtain which-path information without scattering the particles or otherwise introducing uncontrolled phase factors to them. Rather than attempting to observe which photon was entering each slit (thus disturbing them), they proposed to "mark" them with information that, in principle at least, would allow the photons to be distinguished after passing through the slits. Lest there be any misunderstanding, the interference pattern does disappear when the photons are so marked. However, the interference pattern reappears if the which-path information is further manipulated after the marked photons have passed through the double slits to obscure the which-path markings. Since 1982, multiple experiments have demonstrated the validity of the so-called quantum "eraser."

A simple quantum eraser experiment

A simple version of the quantum eraser can be described as follows: Rather than splitting one photon or its probability wave between two slits, the photon is subjected to a beam splitter. If one thinks in terms of a stream of photons being randomly directed by such a beam splitter to go down two paths that are kept from interaction, it would seem that no photon can then interfere with any other or with itself.

However, if the rate of photon production is reduced so that only one photon is entering the apparatus at any one time, it becomes impossible to understand the photon as only moving through one path, because when the path outputs are redirected so that they coincide on a common detector or detectors, interference phenomena appear.

In the two diagrams in Fig. 1, photons are emitted one at a time from a laser symbolized by a yellow star. They pass through a 50% beam splitter (green block) that reflects or transmits 1/2 of the photons. The reflected or transmitted photons travel along two possible paths depicted by the red or blue lines.

In the top diagram, the trajectories of the photons are clearly known: If a photon emerges from the top of the apparatus, it had to have come by way of the blue path, and if it emerges from the side of the apparatus, it had to have come by way of the red path.

In the bottom diagram, a second beam splitter is introduced at the top right. It can direct either beam toward either exit port. Thus, photons emerging from each exit port may have come by way of either path. By introducing the second beam splitter, the path information has been "erased". Erasing the path information results in interference phenomena at detection screens positioned just beyond each exit port. What issues to the right side displays reinforcement, and what issues toward the top displays cancellation.

Delayed choice

Elementary precursors to current quantum eraser experiments such as the "simple quantum eraser" described above have straightforward classical-wave explanations. Indeed, it could be argued that there is nothing particularly quantum about this experiment. Nevertheless, Jordan has argued on the basis of the correspondence principle, that despite the existence of classical explanations, first-order interference experiments such as the above can be interpreted as true quantum erasers.

These precursors use single-photon interference. Versions of the quantum eraser using entangled photons, however, are intrinsically non-classical. Because of that, in order to avoid any possible ambiguity concerning the quantum versus classical interpretation, most experimenters have opted to use nonclassical entangled-photon light sources to demonstrate quantum erasers with no classical analog.

Furthermore, use of entangled photons enables the design and implementation of versions of the quantum eraser that are impossible to achieve with single-photon interference, such as the delayed choice quantum eraser which is the topic of this article.

The experiment of Kim et al. (2000)

The experimental setup, described in detail in Kim et al., is illustrated in Fig 2. An argon laser generates individual 351.1 nm photons that pass through a double slit apparatus (vertical black line in the upper left hand corner of the diagram).

An individual photon goes through one (or both) of the two slits. In the illustration, the photon paths are color-coded as red or light blue lines to indicate which slit the photon came through (red indicates slit A, light blue indicates slit B).

So far, the experiment is like a conventional two-slit experiment. However, after the slits, spontaneous parametric down conversion (SPDC) is used to prepare an entangled two-photon state. This is done by a nonlinear optical crystal BBO (beta barium borate) that converts the photon (from either slit) into two identical, orthogonally polarized entangled photons with 1/2 the frequency of the original photon. The paths followed by these orthogonally polarized photons are caused to diverge by the Glan-Thompson Prism.

One of these 702.2 nm photons, referred to as the "signal" photon (look at the red and light-blue lines going upwards from the Glan-Thompson prism) continues to the target detector called D₀. During an experiment, detector D₀ is scanned along its x-axis, its motions controlled by a step motor. A plot of "signal" photon counts detected by D₀ versus x can be examined to discover whether the cumulative signal forms an interference pattern.

The other entangled photon, referred to as the "idler" photon (look at the red and light-blue lines going downwards from the Glan-Thompson prism), is deflected by prism PS that sends it along divergent paths depending on whether it came from slit A or slit B.

Somewhat beyond the path split, the idler photons encounter beam splitters BS_a, BS_b, and BS_c that each have a 50% chance of allowing the idler photon to pass through and a 50% chance of causing it to be reflected. M_a and M_b are mirrors.

The beam splitters and mirrors direct the idler photons towards detectors labeled D₁, D₂, D₃ and D₄. Note that:

Detection of the idler photon by D₃ or D₄ provides delayed "which-path information" indicating whether the signal photon with which it is entangled had gone through slit A or B. On the other hand, detection of the idler photon by D₁ or D₂ provides a delayed indication that such information is not available for its entangled signal photon. Insofar as which-path information had earlier potentially been available from the idler photon, it is said that the information has been subjected to a "delayed erasure".

By using a coincidence counter, the experimenters were able to isolate the entangled signal from photo-noise, recording only events where both signal and idler photons were detected (after compensating for the 8 ns delay). Refer to Figs 3 and 4.

Significance

This result is similar to that of the double-slit experiment since interference is observed when it is not known which slit the photon went through, while no interference is observed when the path is known.

However, what makes this experiment possibly astonishing is that, unlike in the classic double-slit experiment, the choice of whether to preserve or erase the which-path information of the idler was not made until 8 ns after the position of the signal photon had already been measured by D₀.

Detection of signal photons at D₀ does not directly yield any which-path information. Detection of idler photons at D₃ or D₄, which provide which-path information, means that no interference pattern can be observed in the jointly detected subset of signal photons at D₀. Likewise, detection of idler photons at D₁ or D₂, which do not provide which-path information, means that interference patterns can be observed in the jointly detected subset of signal photons at D₀.

In other words, even though an idler photon is not observed until long after its entangled signal photon arrives at D₀ due to the shorter optical path for the latter, interference at D₀ is determined by whether a signal photon's entangled idler photon is detected at a detector that preserves its which-path information (D₃ or D₄), or at a detector that erases its which-path information (D₁ or D₂).

Some have interpreted this result to mean that the delayed choice to observe or not observe the path of the idler photon changes the outcome of an event in the past. However, the consensus contemporary position is that retrocausality is not necessary to explain the phenomenon of delayed choice. Note in particular that an interference pattern may only be pulled out for observation after the idlers have been detected (i.e., at D₁ or D₂).

The total pattern of all signal photons at D₀, whose entangled idlers went to multiple different detectors, will never show interference regardless of what happens to the idler photons. One can get an idea of how this works by looking at the graphs of R₀₁, R₀₂, R₀₃, and R₀₄, and observing that the peaks of R₀₁ line up with the troughs of R₀₂ (i.e. a π phase shift exists between the two interference fringes). R₀₃ shows a single maximum, and R₀₄, which is experimentally identical to R₀₃ will show equivalent results. The entangled photons, as filtered with the help of the coincidence counter, are simulated in Fig. 5 to give a visual impression of the evidence available from the experiment. In D₀, the sum of all the correlated counts will not show interference. If all the photons that arrive at D₀ were to be plotted on one graph, one would see only a bright central band.

Possibility of retrocausality

Delayed choice experiments raise questions about time and time sequences, and thereby bring our usual ideas of time and causal sequence into question. If events at D₁, D₂, D₃, D₄ determine outcomes at D₀, then effect seems to precede cause. If the idler light paths were greatly extended so that a year goes by before a photon shows up at D₁, D₂, D₃, or D₄, then when a photon shows up in one of these detectors, it would cause a signal photon to have shown up in a certain mode a year earlier. Alternatively, knowledge of the future fate of the idler photon would determine the activity of the signal photon in its own present. Neither of these ideas conforms to the usual human expectation of causality. However, knowledge of the future, which would be a hidden variable, was refuted in experiments.

Does delayed choice violate causality?

Experiments that involve entanglement exhibit phenomena that may make some people doubt their ordinary ideas about causal sequence. In the delayed choice quantum eraser, an interference pattern will form on D₀ even if which-path data pertinent to photons that form it are only erased later in time than the signal photons that hit the primary detector. Not only that feature of the experiment is puzzling; D₀ can, in principle at least, be on one side of the universe, and the other four detectors can be "on the other side of the universe" to each other.

However, the interference pattern can only be seen retroactively once the idler photons have been detected and the experimenter has had information about them available, with the interference pattern being seen when the experimenter looks at particular subsets of signal photons that were matched with idlers that went to particular detectors.

Moreover, the apparent retroactive action vanishes if the effects of observations on the state of the entangled signal and idler photons are considered in the historic order. Specifically, in the case when detection/deletion of which-way information happens before the detection on D₀, the standard simplistic explanation says "The detector D_i, at which the idler photon is detected, determines the probability distribution at D₀ for the signal photon". Similarly, in the case when D₀ precedes detection of the idler photon, the following description is just as accurate: "The position at D₀ of the detected signal photon determines the probabilities for the idler photon to hit either of D₁, D₂, D₃ or D₄". These are just equivalent ways of formulating the correlations of entangled photons' observables in an intuitive causal way, so one may choose any of those (in particular, that one where the cause precedes the consequence and no retrograde action appears in the explanation).

The total pattern of signal photons at the primary detector never shows interference (see Fig. 5), so it is not possible to deduce what will happen to the idler photons by observing the signal photons alone. The delayed choice quantum eraser does not communicate information in a retro-causal manner because it takes another signal, one which must arrive via a process that can go no faster than the speed of light, to sort the superimposed data in the signal photons into four streams that reflect the states of the idler photons at their four distinct detection screens.

In fact, a theorem proved by Phillippe Eberhard shows that if the accepted equations of relativistic quantum field theory are correct, it should never be possible to experimentally violate causality using quantum effects. (See reference for a treatment emphasizing the role of conditional probabilities.)

In addition to challenging our common sense ideas of temporal sequence in cause and effect relationships, this experiment is among those that strongly attack our ideas about locality, the idea that things cannot interact unless they are in contact, if not by being in direct physical contact then at least by interaction through magnetic or other such field phenomena.

Against consensus

Despite Eberhard's proof, some physicists have speculated that these experiments might be changed in a way that would be consistent with previous experiments, yet which could allow for experimental causality violations.

Other delayed choice quantum eraser experiments

Many refinements and extensions of Kim et al.'s delayed choice quantum eraser have been performed or proposed. Only a small sampling of reports and proposals are given here:

Scarcelli et al. (2007) reported on a delayed-choice quantum eraser experiment based on a two-photon imaging scheme. After detecting a photon which passed through a double-slit, a random delayed choice was made to erase or not erase the which-path information by the measurement of its distant entangled twin; the particle-like and wave-like behavior of the photon were then recorded simultaneously and respectively by only one set of joint detectors.

Peruzzo et al. (2012) have reported on a quantum delayed choice experiment, based on a quantum controlled beam-splitter, in which particle and wave behaviors were investigated simultaneously. The quantum nature of the photon's behavior was tested via a Bell inequality, which replaced the delayed choice of the observer.

The construction of solid state electronic Mach-Zehnder interferometers (MZI) has led to proposals to use them in electronic versions of quantum eraser experiments. This would be achieved by Coulomb coupling to a second electronic MZI acting as a detector.

Entangled pairs of neutral kaons have also been examined and found suitable for investigations using quantum marking and quantum erasure techniques.