Country Australia Commission date 1965 Type Steam turbines Phone +61 7 4992 9329 Units operational 8 | Status Baseload Primary fuel Coal Owner CS Energy Construction cost 28.7 million USD | |
Location Biloela, Central Queensland Address Lot 14 Biloela Callide Rd, Dumgree QLD 4715, Australia | ||
Callide dam near full callide power station in background zoyts
Callide Power Station is located near Biloela, in Central Queensland, Australia. It is coal powered with eight steam turbines with a combined generation capacity of 1,720 MW of electricity. Callide A was commissioned in 1965 and refurbished in 1998.
Contents
- Callide dam near full callide power station in background zoyts
- Callide AEdit
- Callide BEdit
- Callide CEdit
- References
The coal for Callide comes from the nearby Callide Coalfields and water from the Awoonga dam and Stag Creek Pipeline.
Callide AEdit
At the end of 1962 approval was granted for a new power station near Biloela. Work commenced at the site in February 1963. The design of the plant based around separate generating units and a control room was a first for Queensland. It was also the first power station in Queensland to use dry cooling towers.
It has four 30 MW steam turbines, the first of which was operating by June 1965. From its commissioning a drought meant water restrictions at the station reduced output. The second set was expected to be operating by May 1966, but was lost at sea while being transported from England. A replacement unit arrived in June 1967. The third set was operating in October 1967 and the fourth in May 1969. The total cost of the project was A$28.7 million.
Callide A has been in storage since 2001, except for Unit 4 which is being used for the Callide Oxyfuel project.
Callide BEdit
Following on from an aggressive construction program at Tarong Power Station, Callide B was commissioned in 1988 with two 350 MW steam turbines. The Hitachi machines are almost identical to those in Tarong and Stanwell.
Callide CEdit
The Callide Power Plant (a.k.a. Callide C) was commissioned in 2001 with two 460 MW advanced cycle steam turbines. Callide C uses a more efficient "supercritical" boiler technology to burn coal to generate electricity.
Carbon Monitoring for Action estimates this power station emits 5.73 million tonnes of greenhouse gases each year as a result of burning coal. The Australian Government introduced a Carbon Pollution Reduction Scheme in 2011 to help combat climate change, intended to reduce emissions from power stations. The scheme was replaced in 2014 by a 'direct action' program. The National Pollutant Inventory provides details of other pollutant emissions, but, as at 23 November 2008, not CO2.