Apple II peripheral cards

The Apple II line of computers supported a number of Apple II peripheral cards, expansion cards which plugged into slots on the motherboard, and added to and extended the functionality of the base system.

Contents

• Categories
• 50 pin standard slots
• Other slot types
• References

All Apple II models except the Apple IIc had at least seven 50-pin expansion slots, labeled Slots 1 though 7. These slots could hold printed circuit board cards with double-sided edge connectors, 25 "fingers" on each side, with 100 mil (0.1 inch) spacing between centers. Slot 3 in an Apple IIe that has an 80-column card fitted (which is usually the case) and Slots 1 through 6 in a normally configured Apple IIgs are "virtually" filled with on-board devices which means that the physical slots cannot be used at all, or only with certain specific cards, unless the offending "virtual" device is disabled.

In addition to the seven standard expansion slots, the following computers contained additional, largely special-purpose expansion slots:

Perhaps the most common cards found on early Apple II systems were the Disk II Controller Card, which allowed users of earlier Apple IIs to use the Apple Disk II, a 5¼ inch, 140 kB floppy disk drive; and the Apple 16K Language Card, which increased the base memory of late-model Apple II and standard Apple II Plus units from 48 kB to 64 kB.

Both Apple, and dozens of third-party vendors created hundreds of cards for the Apple II series of computers. These expansion slots afforded great opportunities for expansion. In the 2000s, long after the last Apple IIe came off Apple's assembly line in 1993, a handful of manufacturers continue to market peripherals and expansion cards for Apple II computers, not counting students, hobbyists, and other Apple II users who continue to push the original machine to its limits.