Trisha Shetty (Editor)

Undertow (water waves)

Updated on
Edit
Like
Comment
Share on FacebookTweet on TwitterShare on LinkedInShare on Reddit

In physical oceanography, undertow is the average under-current which is moving offshore when waves are approaching a shore. Undertow is a necessary and universal feature: it is a return flow compensating for the onshore-directed average transport of water by the waves in the zone above the wave troughs. The undertow's flow velocities are generally strongest in the surf zone, where the water is shallow and the waves are high due to shoaling.

Contents

In popular usage, the word "undertow" is often misapplied to rip currents. An undertow occurs everywhere underneath shore-approaching waves, whereas rip currents are localized narrow offshore currents occurring at certain locations along the coast. Unlike undertow, rip currents are strong at the surface.

Oceanography

An "undertow" is a steady, offshore-directed compensation flow, which occurs below waves near the shore. Physically, nearshore, the wave-induced mass flux between wave crest and trough is onshore directed. This mass transport is localized in the upper part of the water column, i.e. above the wave troughs. To compensate for the amount of water being transported towards the shore, a second-order (i.e. proportional to the wave height squared), offshore-directed mean current takes place in the lower section of the water column. This flow – the undertow – affects the nearshore waves everywhere, unlike rip currents localized at certain positions along the shore.

The term undertow is used in scientific coastal oceanography papers. The distribution of flow velocities in the undertow over the water column is important as it strongly influences the on- or offshore transport of sediment. Outside the surf zone there is a near-bed onshore-directed sediment transport induced by Stokes drift and skewed-asymmetric wave transport. In the surf zone, strong undertow generates a near-bed offshore sediment transport. These antagonistic flows may lead to sand bar formation where the flows converge near the wave breaking point, or in the wave breaking zone.

Seaward mass flux

An exact relation for the mass flux of a nonlinear periodic wave on an inviscid fluid layer was established by Levi-Civita in 1924. In a frame of reference according to Stokes' first definition of wave celerity, the mass flux M w of the wave is related to the wave's kinetic energy density E k (integrated over depth and thereafter averaged over wavelength) and phase speed c through:

M w = 2 E k c .

Similarly, Longuet Higgins showed in 1975 that – for the common situation of zero mass flux towards the shore (i.e. Stokes' second definition of wave celerity) – normal-incident periodic waves produce a depth- and time-averaged undertow velocity:

u ¯ = 2 E k ρ c h ,

with h the mean water depth and ρ the fluid density. The positive flow direction of u ¯ is in the wave propagation direction.

For small-amplitude waves, there is equipartition of kinetic ( E k ) and potential energy ( E p ):

E w = E k + E p 2 E k 2 E p ,

with E w the total energy density of the wave, integrated over depth and averaged over horizontal space. Since in general the potential energy E p is much easier to measure than the kinetic energy, the wave energy is approximately E w 1 8 ρ g H 2 (with H the wave height). So

u ¯ 1 8 g H 2 c h .

For irregular waves the required wave height is the root-mean-square wave height H rms 8 σ , with σ the standard deviation of the free-surface elevation. The potential energy is E p = 1 2 ρ g σ 2 and E w ρ g σ 2 .

The distribution of the undertow velocity over the water depth is a topic of ongoing research.

Confusion with rip currents

In popular usage, the word "undertow" is sometimes used correctly, in the same sense it is in oceanography. However the term "undertow" is also often used incorrectly, in the mistaken belief that near beaches there is a water flow or current that can pull a person down vertically and hold them underwater until they drown. This misconception stems from a basic lack of knowledge about water currents, and from confusing undertow (which is usually not dangerous) with the more substantial dangers of rip currents. Rip currents also cannot pull a person down, but they can carry a person out beyond the zone of the breaking waves.

In contrast to undertow, rip currents are responsible for the great majority of drownings close to beaches. When a swimmer enters a rip current, it starts to carry the person offshore. If the swimmer understands how to deal with this situation, he or she can easily exit the rip current by swimming at right angles to the flow, in other words swimming parallel to the shore, or by simply treading water or floating. However, if the swimmer does not know these simple solutions, or does not possess the necessary water skills, they may panic and drown, or they may exhaust themselves by trying unsuccessfully to swim directly against the flow.

On the United States Lifesaving Association website it is explained that some uses of the word "undertow" are incorrect:

A rip current is a horizontal current. Rip currents do not pull people under the water–-they pull people away from shore. Drowning deaths occur when people pulled offshore are unable to keep themselves afloat and swim to shore. This may be due to any combination of fear, panic, exhaustion, or lack of swimming skills.

In some regions rip currents are referred to by other, incorrect terms such as 'rip tides' and 'undertow'. We encourage exclusive use of the correct term – rip currents. Use of other terms may confuse people and negatively impact public education efforts.

References

Undertow (water waves) Wikipedia