Trimix (breathing gas)

Advantages of helium in the mix

The main reason for adding helium to the breathing mix is to reduce the proportions of nitrogen and oxygen below those of air, to allow the gas mix to be breathed safely on deep dives. A lower proportion of nitrogen is required to reduce nitrogen narcosis and other physiological effects of the gas at depth. Helium has very little narcotic effect. A lower proportion of oxygen reduces the risk of oxygen toxicity on deep dives.

The lower density of helium reduces breathing resistance at depth.

Because of its low molecular weight, helium enters and leaves tissues more rapidly than nitrogen as the pressure is increased or reduced (this is called on-gassing and off-gassing). Because of its lower solubility, helium does not load tissues as heavily as nitrogen, but at the same time the tissues can not support as high an amount of helium when super-saturated. In effect, helium is a faster gas to saturate and desaturate, which is a distinct advantage in saturation diving, but less so in bounce diving, where the increased rate of off-gassing is largely counterbalanced by the equivalently increased rate of on-gassing.

Disadvantages of helium in the mix

Helium conducts heat six times faster than air; often helium breathing divers carry a separate supply of a different gas to inflate drysuits. This is to avoid the risk of hypothermia caused by using helium as inflator gas. Argon, carried in a small, separate tank, connected only to the inflator of the drysuit is preferred to air, since air conducts heat 50% faster than argon. Dry suits (if used together with a buoyancy compensator) still require a minimum of inflation to avoid "squeezing", i.e. damage to skin caused by pressurizing dry suit folds.

Some divers suffer from hyperbaric arthralgia (compression arthralgia) during descent and trimix has been shown to help symptoms on compression.

Helium dissolves into tissues more rapidly than nitrogen as the ambient pressure is increased (this is called on-gassing). A consequence of the higher loading in some tissues is that many decompression algorithms require deeper decompression stops than a similar decompression dive using air, and helium is more likely to come out of solution and cause decompression sickness following a fast ascent.

In addition to physiological disadvantages, the use of trimix also has economic and logistic disadvantages. The price of helium has increased by over 51% between the years 2000 and 2011. This price increase affects open-circuit divers more than closed-circuit divers due to the larger volume of helium consumed on a typical trimix dive. Additionally, as trimix fills require a more elaborate blending and compressor setup than less complex air and nitrox fills, there are fewer trimix filling stations. The relative scarcity of trimix filling stations may necessitate going far out of one's way in order to procure the necessary mix for a deep dive that requires the gas.

Advantages of reducing oxygen in the mix

Lowering the oxygen content increases the maximum operating depth and duration of the dive before which oxygen toxicity becomes a limiting factor. Most trimix divers limit their working oxygen partial pressure [PO₂] to 1.4 bar and may reduce the PO₂ further to 1.3 bar or 1.2 bar depending on the depth, the duration and the kind of breathing system used. A maximum oxygen partial pressure of 1.4 bar for the active sectors of the dive, and 1.6 bar for decompression stops is recommended by several recreational and technical diving certification agencies for open circuit, and 1.2 bar or 1.3 bar as maximum for the active sectors of a dive on closed circuit rebreather.

Advantages of keeping some nitrogen in the mix

Retaining nitrogen in trimix can contribute to the prevention of High Pressure Nervous Syndrome, a problem that can occur when breathing heliox at depths beyond about 130 metres (430 ft). Nitrogen is also much less expensive than helium.

Naming conventions

Conventionally, the mix is named by its oxygen percentage, helium percentage and optionally the balance percentage, nitrogen. For example, a mix named "trimix 10/70" or trimix 10/70/20, consisting of 10% oxygen, 70% helium, 20% nitrogen is suitable for a 100-metre (330 ft) dive.

The ratio of gases in a particular mix is chosen to give a safe maximum operating depth and comfortable equivalent narcotic depth for the planned dive. Safe limits for mix of gases in trimix are generally accepted to be a maximum partial pressure of oxygen (PO₂—see Dalton's law) of 1.0 to 1.6 bar and maximum equivalent narcotic depth of 30 to 50 m (100 to 160 ft). At 100 m (330 ft), "12/52" has a PO₂ of 1.3 bar and an equivalent narcotic depth of 43 m (141 ft).

In open-circuit scuba, two classes of trimix are commonly used: normoxic trimix—with a minimum PO2 at the surface of 0.18 and hypoxic trimix—with a PO2 less than 0.18 at the surface. A normoxic mix such as "19/30" is used in the 30 to 60 m (100 to 200 ft) depth range; a hypoxic mix such as "10/50" is used for deeper diving, as a bottom gas only, and cannot safely be breathed at shallow depths where the PO₂ is less than 0.18 bar.

In fully closed circuit rebreathers that use trimix diluents, the mix can be hyperoxic in shallow water because the rebreather automatically adds oxygen to maintain a specific PO₂. Less commonly, hyperoxic trimix is sometimes used on open circuit scuba. Hyperoxic trimix is sometimes referred to as Helitrox, TriOx, or HOTx (High Oxygen Trimix) with the "x" in HOTx representing the mixture's fraction of helium as a percentage.

See breathing gas for more information on the composition and choice of gas blends.

Blending

Gas blending of trimix involves decanting oxygen and helium into the diving cylinder and then topping up the mix with air from a diving air compressor. To ensure an accurate mix, after each helium and oxygen transfer, the mix is allowed to cool, its pressure is measured and further gas is decanted until the correct pressure is achieved. This process often takes hours and is sometimes spread over days at busy blending stations.

A second method called 'continuous blending' is now gaining favor. Oxygen, helium and air are blended on the intake side of a compressor. The oxygen and helium are fed into the air stream using flow meters, so as to achieve the rough mix. The low pressure mixture is analyzed for oxygen content and the oxygen and helium flows adjusted accordingly. On the high pressure side of the compressor a regulator is used to reduce pressure of a sample flow and the trimix is analyzed (preferably for both helium and oxygen) so that the fine adjustment to the intake gas flows can be made.

The benefit of such a system is that the helium delivery tank pressure need not be as high as that used in the partial pressure method of blending and residual gas can be 'topped up' to best mix after the dive. This is important mainly because of the high cost of helium.

Drawbacks may be that the high heat of compression of helium results in the compressor overheating (especially in tropical climates) and that the hot trimix entering the analyzer on the high pressure side can affect the reliability of the analysis.. DIY versions of the continuous blend units can be made for as little as $200 (excluding analyzers).

"Standard" mixes

Although theoretically trimix can be blended with almost any combination of helium and oxygen, a number of "standard" mixes have evolved (such as 21/35, 18/45 and 15/55—see Naming conventions). Most of these mixes originated from filling the cylinders with a certain percentage of helium, and then topping the mix with 32% enriched air nitrox. The "standard" mixes evolved because of three coinciding factors—the desire to keep that equivalent narcotic depth (END) of the mix at approximately 34 metres (112 ft), the requirement to keep the partial pressure of oxygen at 1.4 ATA or below at the deepest point of the dive, and the fact that many dive shops stored standard 32% enriched air nitrox in banks, which simplified mixing. The use of standard mixes makes it relatively easy to top up diving cylinders after a dive using residual mix—only helium and banked nitrox needs to be used to top up the residual gas from the last fill.

The method of mixing a known nitrox mix with helium allows analysis of the fractions of each gas using only an oxygen analyser, since the ratio of the oxygen fraction in the final mix to the oxygen fraction in the initial nitrox gives the fraction of nitrox in the final mix, hence the fractions of the three components are easily calculated. It is demonstrably true that the END of a nitrox-helium mixture at its maximum operating depth (MOD) is equal to the MOD of the nitrox alone.

Heliair

Heliair is a breathing gas consisting of mixture of oxygen, nitrogen and helium and is often used during the deep phase of dives carried out using technical diving techniques. This term, first used by Sheck Exley, is mostly used by Technical Diving International.

It is easily blended from helium and air and so has a fixed 21:79 ratio of oxygen to nitrogen with the balance consisting of a variable amount of helium. It is sometimes referred to as "poor man's trimix", because it is much easier to blend than trimix blends with variable oxygen content, since all that is required is to insert the requisite partial pressure of helium, and then top up with air from a conventional compressor. The more complicated (and dangerous) step of adding pure oxygen at pressure required to blend trimix is absent when blending heliair.

Heliair blends are similar to the standard Trimix blends made with helium and Nitrox 32, but with a deeper END at MOD. Heliair will always have less than 21% oxygen, and will be hypoxic (less than 17% oxygen) for mixes with more than 20% helium.

Hyperoxic trimix

The National Association of Underwater Instructors (NAUI) uses the term "helitrox" for hyperoxic 26/17 Trimix, i.e. 26% oxygen, 17% helium, 57% nitrogen. Helitrox requires decompression stops similar to Nitrox-I (EAN32) and has a maximum operating depth of 44 metres (144 ft), where it has an equivalent narcotic depth of 35 metres (115 ft). This allows diving throughout the usual recreational range, while decreasing decompression obligation and narcotic effects compared to air.

GUE and UTD also promote hyperoxic trimix, but prefer the term "TriOx".

Other divers question whether this proliferation of terminology is useful, and feel that the term Trimix is sufficient, modified as appropriate with the terms hypoxic, normoxic and hyperoxic, and the usual forms for indicating constituent gas fraction.

History as a diving gas

1919

Professor Elihu Thomson speculates that helium could be used instead of nitrogen to reduce the breathing resistance at great depth. The effects from narcosis was not proven until the salvage of the USS Squalus in 1939. Heliox was used with air tables resulting in a high incidence of decompression sickness so the use of helium was discontinued.

1924

The US Navy begins examining helium's potential usage and by the mid-1920s lab animals were exposed to experimental chamber dives using heliox. Soon, human subjects breathing heliox 20/80 (20% oxygen, 80% helium) had been successfully decompressed from deep dives.

1937

Several test dives are conducted with helium mixtures, including salvage diver Max "Gene" Nohl's dive to 127 meters.

1939

US Navy used heliox in USS Squalus salvage operation.

1965

Nic Flemming's work to study sand ribbons in the English Channel became the first studies comparing diver performance while breathing air and heliox in the open-water.

1963

First saturation dives using trimix as part of Project Genesis.

1970

Hal Watts performs dual body recovery at Mystery Sink (126 m).

1979

A research team headed by Peter B. Bennett at the Duke University Medical Center Hyperbaric Laboratory began the "Atlantis Dive Series" which proved the mechanisms behind the use of trimix to prevent High Pressure Nervous Syndrome symptoms.

1983

Cave diver Jochen Hasenmayer uses heliox to a depth of 212 meters. Depth is later repeated by Sheck Exley in 1987.

1987

First mass use of trimix and heliox: Wakulla Springs Project. Exley teaches non-commercial divers in relation to trimix usage in cave diving.

1991

Billy Deans commences teaching of trimix diving for recreational diving. Tom Mount develops first trimix training standards (IANTD). Use of trimix spreads rapidly to North East American wreck diving community.

1992

The National Oceanographic and Atmospheric Administration (NOAA) develops "Monitor Mix" for dives to the USS Monitor. This mix became NOAA Trimix I, with decompression tables designed by Bill Hamilton published in the NOAA Diving Manual.

1992

NOAA attains training from Key West Divers to conduct the first NOAA-sponsored trimix dives on the wreck of USS Monitor off Cape Hatteras, NC.

1994

Combined UK/USA team, including wreck divers John Chatterton and Gary Gentile, successfully complete a series of wreck dives on the RMS Lusitania expedition to a depth of 100 meters using trimix.

1994

Sheck Exley and Jim Bowden use "heliair" at Zacaton in the first attempt to make an open circuit scuba dive to 1000 ft. Exley, at the time holding the world record for an 881-foot dive, passes out and dies around 900 feet; Bowden aborts at 925 feet and survives despite several life-threatening obstacles.

2001

The Guinness Book of records recognises John Bennett as the first scuba diver to dive to 1000 ft, using Trimix.

2005

David Shaw sets depth record for using a trimix rebreather, dying while repeating the dive.

2015

The United States Navy Experimental Diving Unit shows that bounce dives using trimix are not more efficient than dives on heliox.

Training and certification

Technical diver training and certification agencies may differentiate between levels of trimix diving qualifications, The usual distinction is between normoxic trimix and hypoxic trimix, sometimes also called full trimix.