Girish Mahajan (Editor)

Signaling System No. 6

Updated on
Edit
Like
Comment
Share on FacebookTweet on TwitterShare on LinkedInShare on Reddit

SS6 or CCITT No 6 Signalling System was introduced in the 1970s as an early common channel signalling method for telephone trunks between International Switching Centres (ISCs). It had limited applications since at that time C4 and C5 signalling systems were still flourishing but there was a need to experience common channel working on a fast digital basis.

The telephone switching in the ISCs was then typically crossbar or electronic controlled cross-points such as reed relays. The transmission media was likely to be satellite or lengthy terrestrial submarine cable channels. In some cases these were advantaged or multiplied with TASI (Time-Assignment Speech Interpolation) or DCME (Digital Circuit Multiplication Equipment). These transmission methods were not suited to Line or Inter-Register signalling. Taking the signalling function away from the traffic channel could cut costs, and would later lead to Common Channel Signalling. There would be no need for filtering signalling away from speech, and the duty cycle of the costly trunk for each revenue earning call would be better. Signalling time in call set up and clear down would be significantly shorter than with C4 and C5. With telephone signalling not transmitted over the line, the opportunities for fraud were reduced.

The CCITT 6 signalling channel was typically a 2.4 kbit/s data link. Technology at the time was an M1040 or M1020 analogue Four-wire circuit presented private circuit link. Modems were slowly beginning to exceed these data rates over 4w circuits; these data links had the advantage that there was no national tail from the ISC out to a normal end point in the country. It was often the National Section that detracted the most from the quality and reliability of such links.

The data circuit known with a DP designation, would have been terrestrial with no TASI or DCME, and the C6 signalling on the data link could perform for 48 or 96 traffic channels. It could function for up to 2,048 in the maximum. The question is whether two operators would have that many traffic channels between them, dependent on just one bearer for signalling and subject to occasional failure. It was of course practice to have standby route over a diverse path in case of outage on the original DP data circuit link.

Finally it was considered possible that a mesh of such data channels could be set up between major centres, leading to a system where the link between country A and country B could perform the signalling functions for links to country A from country D for example.

CCITT No 6 was a method developed & implemented by administrations in a limited number of countries for use in correspondent International Switching of analogue telephone calls. The next development was correspondent and non-correspondent switching of telephone calls by new operators in the countries where more sophisticated methods were required.

References

Signaling System No. 6 Wikipedia