Samiksha Jaiswal (Editor)

NZR UB class

Updated on
Edit
Like
Comment
Share on FacebookTweet on TwitterShare on LinkedInShare on Reddit
Build date
  
1898, 1901

Configuration
  
Driver dia.
  
49.125 in (1.248 m)

Total produced
  
22

Gauge
  
3 ft 6 in (1,067 mm)

The NZR UB class were a series of Ten Wheelers built by American manufacturers around the start of the twentieth century. Two batches were built by Baldwin in 1898 and 1901 (ten each). The earlier engines had slide valves and Stephenson motion, the later had piston valves and Walschaerts valve gear, as well as a higher boiler pressure. Two additional locomotives were obtained in 1901 from ALCO, one each from Brooks and Richmond. The Brooks locomotive (#17) was heavier (30.1 LT adhesive) with attendant increase in tractive effort (18340 lbf), and had a larger grate (17 sq ft). This locomotive was very popular with crews. The Richmond locomotive had less evaporative heating surface but included a superheater. Boiler pressure was lower (180 psi) and tractive effort was marginally lower. The locomotives were initially assigned to Dunedin to Christchurch expresses and were reassigned as newer power replaced them. The last assignment for the class was on the West Coast Region.

Preservation

While they are still some Ub's dumped even at Omoto, a few from Oamaru where also dumped in the forshore, Ub 17 of (ALCO) built and 282 a Baldwin built example, both engines where recovered and later sent to Waitara to their Hooterville Heritage Charitable Trust depot, and are both awaiting restoration,

References

NZR UB class Wikipedia