Kalpana Kalpana (Editor)

Genezareth, Hallum

Updated on
Edit
Like
Comment
Share on FacebookTweet on TwitterShare on LinkedInShare on Reddit
Purpose
  
Drainage mill

Base storeys
  
Single-storey base

Province
  
Friesland

Windshaft
  
Cast iron

Storeys
  
Three-storey smock

Year built
  
1850

Type of pump
  
Archimedes' screw

Genezareth, Hallum

Mill name
  
Genezareth Kloosterpoldermolen

Mill location
  
Trekweg 8, 9074 LE Hallum

Operator(s)
  
Stichting De Fryske Mole

Address
  
9074 LD Hallum, Netherlands

Similar
  
Slagdijkstermolen - Finkum, De Huinsermolen - Húns, De Edensermolen, De Gans - Ezumazijl, De Ouderkerkermolen - Aldtsjerk

The Genezareth or Kloosterpoldermolen is a smock mill in Hallum, Friesland, Netherlands which was built in 1850 and has been restored to working order. The mill is listed as a Rijksmonument, number 15642.

Contents

History

The Genezareth was built in 1850 by millwright H de Vries to drain the Genezareth-Kloosterpolder. Restorations were undertaken in 1958 and 1962. On 4 May 1976, the mill was sold to Stichting De Fryske Mole (English: Frisian Mills Foundation) A further restoration was undertaken in 1980. In 2006, the mill was officially designated as being in reserve should it be required to drain the polder.

Description

The Genezareth is what the Dutch describe as a Grondzeiler. It is a three-storey smock mill on a single-storey brick base.There is no stage, the sails reaching down almost to the ground. The smock and cap are thatched. The cap is winded by tailpole and winch. The sails are Common sails, they have a span of 15.92 metres (52 ft 3 in). The sails are carried on a cast-iron windshaft, which was cast by H J Koening of Foxham, Groningen in 1900. The windshaft carries the brake wheel, which has 47 cogs. This drives the wallower (25 cogs) at the top of the upright shaft. At the bottom of the upright shaft, a crown wheel with 35 cogs drives a gear with 35 cogs on the axle of the Archimedes' screw. The axle of the Archimedes' screw is 340 millimetres (13¼ in) diameter. The Archimedes' screw is 1.29 metres (4 ft 3 in) diameter and 3.86 metres (12 ft 8 in) long. It is inclined at an angle of 17½°. Each revolution of the Archimedes' screw lifts 600 litres (130 imp gal) of water.

Public access

The Genezareth is open to the public by appointment, or if it is working.

References

Genezareth, Hallum Wikipedia